19mm Irrigation fittings

Used to connect 19 mm poly tube..

Used to connect 1/2” male fittings into 19 mm poly tube, eg. poly risers...

Used to connect 1/2” female fittings into 19 mm poly tube, eg. pop up sprinklers..

Used to connect 1/2” female fittings into 19 mm poly tube, eg. pop up sprinklers..

Designed for use with LDPE pipe.Secure with CT23 clasps...

Designed for use with LDPE pipe.  Elbow to fit 19mm with 1/2” male fitting suitable for poy risers and other irrigation fittings with female 1/2” fitting.Secure with CT23 clasps...

Designed for use with LDPE pipe.  Elbow to fit 19mm with 3/4” male fitting suitable for poy risers and other irrigation fittings with female 3/4” fitting.Secure with CT23 clasps...

On off valve to connect to 19mm polytube..

Fitting that enables you to join 19mm polytube to a 1/2” female fitting..

Fitting that enables you to join 19mm polytube to a 3/4” female fitting..

Philmac19mm Inline cartridge filter stops the dirt and grit from dirty water entering the irrigation system and blocking drippers and sprays.It can be secured with 19mm locking clamps, requires simple maintenance and can be situated anywhere on line, ideally before drippers...

Pack of 5 19mm joiners to join 19mm polytube.Best used with tube clips CT23..

The end plug will seal off the end of 19mm polytube and can be removed at a later time if you wish to extend the line.Secure with CT23 tube clips.Philmac static fittings have been designed to suit Low Density Polyethylene (LDPE) pipe with an expected maximum pressure of 300 kPa. The metric s..

Hose clamps should be used with all barbed irrigation fittings to stop the hose from coming off the fitting.Use these clamps with 19mm barb fittings.  Supplied in a pack of 10...