25mm Irrigation fittings

Used to connect 25 mm poly tube..

Used to connect 1/2” male fittings into 25 mm poly tube, eg. poly risers...

Used to connect 1/2” female fittings into 25 mm poly tube, eg. pop up sprinklers..

Used to connect 3/4” female fittings into 25 mm poly tube, eg. pop up sprinklers..

Designed for use with LDPE pipe.Secure with CT29 clasps...

Designed for use with LDPE pipe.  25mm hose fitting with elbow to attach to 1/2” fittings with female thread.Secure with CT29 clasps...

Designed for use with LDPE pipe.  25mm hose fitting with elbow to attach to 3/4” fittings with female thread.Secure with CT29 clasps...

On off valve to connect to 25mm polytube..

Fitting that enables you to join 25mm polytube to a 1” female fitting..

Fitting that enables you to join 25mm polytube to a 3/4” female fitting..

Philmac 25mm Inline cartridge filter stops the dirt and grit from dirty water entering the irrigation system and blocking drippers and sprays.It can be secured with 25mm locking clamps, requires simple maintenance and can be situated anywhere on line, ideally before drippers...

Pack of 5 25mm joiners to join 25mm polytube.Best used with tube clips CT29..

The end plug will seal off the end of 25mm polytube and can be removed at a later time if you wish to extend the line.Secure with CT29 tube clips.Philmac static fittings have been designed to suit Low Density Polyethylene (LDPE) pipe with an expected maximum pressure of 300 kPa. The metric s..

Hose clamps should be used with all barbed irrigation fittings to stop the hose from coming off the fitting.Use these clamps with 25mm barb fittings.  Supplied in a pack of 10...